|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-30-2015, 12:01 PM | #1 |
Senior Member
Join Date: May 2010
Location: Sugar Land, TX
Posts: 4,395
|
ID manifolds for 46-48 engine in 41
|
11-30-2015, 12:13 PM | #2 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,950
|
Re: ID manifolds for 46-48 engine in 41
There should be a casting part # on each manifold.
It's probably where you can't see it without using a mirror or "rubbing" it using pencil and paper. Get that number and you will know for sure. Last edited by 19Fordy; 11-30-2015 at 12:18 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
11-30-2015, 01:40 PM | #3 |
Senior Member
Join Date: Oct 2011
Location: Shelton, WA
Posts: 3,800
|
Re: ID manifolds for 46-48 engine in 41
Looks like a 59 series engine with 37-41 exhaust manifolds to me. 41s should have the fan on the crank.
|
11-30-2015, 03:55 PM | #4 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,950
|
Re: ID manifolds for 46-48 engine in 41
I agree. Could be a 1947 Ford engine like this one that was removed from a 41 Ford coupe last week. Post a photo of the distributor if possible.
Last edited by 19Fordy; 11-30-2015 at 04:06 PM. |
11-30-2015, 04:10 PM | #5 |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,115
|
Re: ID manifolds for 46-48 engine in 41
Also, note the CHANGED direction of the anti-chatter rods as seen in your pics, as well as in this pic, and Jim's pic. DD
|
11-30-2015, 04:22 PM | #6 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,950
|
Re: ID manifolds for 46-48 engine in 41
Sponsored Links (Register now to hide all advertisements)
Did any other Ford engines use those forward facing chatter rods? |
11-30-2015, 04:57 PM | #7 |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,115
|
Re: ID manifolds for 46-48 engine in 41
Seems I remember the '41-'47s (at least), and most-likely the '48s, too. DD
|
11-30-2015, 07:18 PM | #8 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,950
|
Re: ID manifolds for 46-48 engine in 41
|
11-30-2015, 07:25 PM | #9 |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 9,012
|
Re: ID manifolds for 46-48 engine in 41
That block is later than '41. The ports for the exhaust manifolds should be "extruded" about 1/4" on a '41 block.
__________________
"I can explain it for you. However, I can't understand it for you". |
|
|
Sponsored Links (Register now to hide all advertisements) |
|