The Ford Barn

carguy01 · 05-22-2013, 05:22 AM

I must be getting real old can someone tell me how the transmission in my 55 ford is held on the crossmember. I have the crossmember with the flat rubber pad but I don't remember how it's secured I have a 3speed O.D.. Does it just sit on the pad any help would be appreciated. Thanks Ralph

Hot Rod Reverend · 05-22-2013, 06:09 AM

Sponsored Links (Register now to hide all advertisements)

Ralph,
The flat pad is secured to the transmission at the part of the pad where the rubber is thick. there should be an elongated, shallow U-shaped piece of metal with a hole on either end to match up to your transmission mount boss. Then, there are two offset holes at the end of the pad that bolt to the transmission crossmember itself.

05-22-2013, 05:22 AM	#1
carguy01 Member Join Date: Aug 2011 Location: ma, Posts: 70	help I must be getting real old can someone tell me how the transmission in my 55 ford is held on the crossmember. I have the crossmember with the flat rubber pad but I don't remember how it's secured I have a 3speed O.D.. Does it just sit on the pad any help would be appreciated. Thanks Ralph

05-22-2013, 06:09 AM	#2
Hot Rod Reverend Senior Member Join Date: May 2010 Location: Lancaster, CA Posts: 916	Re: help Sponsored Links (Register now to hide all advertisements) Ralph, The flat pad is secured to the transmission at the part of the pad where the rubber is thick. there should be an elongated, shallow U-shaped piece of metal with a hole on either end to match up to your transmission mount boss. Then, there are two offset holes at the end of the pad that bolt to the transmission crossmember itself. __________________ Lancaster, California Visit hotrodreverend.com to view hundreds of pictures and videos of the build of the 1955 Ford Club Sedan!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode