|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-20-2011, 09:23 AM | #1 |
Senior Member
Join Date: May 2010
Location: Miami, Florida
Posts: 423
|
1939 Intake Manifold Vacuum Fittings
Does anyone know the size of the fittings that screw into the vacuum holes in a 1939 intake manifold(I believe these are the same for 32 to 38 as well). There are two threaded holes next to the intake runners. One near the third runner from the front for the distributor and one near the third runner from the back for the windshield wiper. These are on the drivers side. Thank you for any help in identifying the size and possible purchase place.
Last edited by Joe KCMO; 09-20-2011 at 11:48 AM. |
09-20-2011, 03:41 PM | #2 |
Member Emeritus
Join Date: May 2010
Location: Madison, NJ
Posts: 5,230
|
Re: 1939 Intake Manifold Vacuum Fittings
I believe these are/were special Weatherheads that worked like a compression fitting pinching in on the tube when tightened...I have the number in an ancient catalog but would be surprised if they are still available. Something odd lik 3/16"
I think Nacewicz can supply repros. |
Sponsored Links (Register now to hide all advertisements) |
|
09-24-2011, 04:31 PM | #3 | |
BANNED
Join Date: May 2010
Location: stratford,ct
Posts: 5,971
|
Re: 1939 Intake Manifold Vacuum Fittings
Quote:
|
|
09-24-2011, 05:53 PM | #4 | |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,995
|
Re: 1939 Intake Manifold Vacuum Fittings
Sponsored Links (Register now to hide all advertisements)
Quote:
I can send you a photo if desired. Mike |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|