|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-27-2011, 11:14 AM | #1 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Neil Wilson...finish on the bolts for rear window frame...
Neil,
What is the correct finish for the small nuts, bolts and lockwashers which hold the rear window and window frame to the back of a Closed Cab body? I know the frame is Gloss Black Enamel...what about the Standard Parts? Thanks. Pluck |
01-27-2011, 04:12 PM | #2 |
Senior Member
Join Date: May 2010
Location: Boulder, CO
Posts: 559
|
Re: Neil Wilson...finish on the bolts for rear window frame...
Steve,
Attached is a picture of what I think the hardware should be. Also attached is a 6-20-28 Ford archive photograph (a crop showing the rear of the cab). Quality is poor. But, one can kind of see that the machine screw is bright and and the nuts are not. Note that there is not a list of hardware in the body parts lists which can be used. I think that the nut and lock washer was raven. But definitely not bright. Also note that the machine screw does not have a blunt end (it is a little cone shaped). I don't know of anyone making them. Most of this type of machine screws were like this. But, the ends can't be seen (like where used in the garnish moldings). |
Sponsored Links (Register now to hide all advertisements) |
|
01-27-2011, 04:25 PM | #3 |
Senior Member
Join Date: May 2010
Location: Mill Creek WA.
Posts: 341
|
Re: Neil Wilson...finish on the bolts for rear window frame...
Steve, The marine industry is big on these type of screws. That is where I would start looking at. They are usually Brass bolts with either chrome or nickel finish. Don
|
01-27-2011, 04:50 PM | #4 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: Neil Wilson...finish on the bolts for rear window frame...
Correct finish on the screws is Nickel Plate...not sure about the nut and lockwasher but as Neil says above they may be BO (Raven) or black or even (not to confuse the issue) body color????
Pluck |
01-28-2011, 12:31 PM | #5 |
Senior Member
Join Date: May 2010
Location: Boulder, CO
Posts: 559
|
Re: Neil Wilson...finish on the bolts for rear window frame...
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|