|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-21-2013, 07:10 AM | #1 |
Senior Member
Join Date: Aug 2011
Location: Cypress, Texas
Posts: 100
|
36 Pickup spline adapter
Who is the best source for a 6 spline to 10 spline adapter? Is the coupling the same as the adapter? Thx Steve
__________________
Restoring 36 pick up |
07-21-2013, 08:31 AM | #2 |
Senior Member
Join Date: May 2010
Location: WA state
Posts: 771
|
Re: 36 Pickup spline adapter
The 10X6 adapter IS the coupling. The adapter will only connect an early 10-spline pinion to a late 6 spine solid drive shaft. These were made by Ford probably for transitional implementation of the change-over. The adapter is often used as a source of 10-spline female material to build custom tube drive shafts.
|
Sponsored Links (Register now to hide all advertisements) |
|
07-21-2013, 02:25 PM | #3 |
Senior Member
Join Date: May 2010
Location: Near Rising Sun, Maryland
Posts: 10,858
|
Re: 36 Pickup spline adapter
The six spline half of a 10x6 spline coupler/adaptor can also be used to replace the ten spline bung end of an early tubular driveshaft, if you are putting a six spline R&P set in an early rear, and do not want to use a solid driveshaft with center bearing torque tube, this might be the best way to go.
Some of those 10x6 spline couplers/adaptors are larger in diameter than the original Ford 6x6 spline coupler/adaptor. I don't believe that larger diameter would cause any problems regardless of how you plan to use it. JMO
__________________
John "Never give up on what you really want to do. The person with big dreams is more powerful than one with all the facts". Albert Einstein |
07-21-2013, 05:41 PM | #4 |
Senior Member
Join Date: Aug 2011
Location: Cypress, Texas
Posts: 100
|
Re: 36 Pickup spline adapter
Sponsored Links (Register now to hide all advertisements)
__________________
Restoring 36 pick up |
|
|
Sponsored Links (Register now to hide all advertisements) |
|