The Ford Barn

fredeuce · 03-27-2023, 05:42 AM

I am going through the clutch pushrods on a '53 Customline.

The bolts are stepped and use wave washers.

The hole that the bolts are inserted into are "D" shaped.

It all looks a bit odd.

Is there meant to be a bush of some kind that goes into these rods?

[IMG]

[/IMG]

38 coupe · 03-30-2023, 06:01 PM

It has been too long since I had those parts off my car for memory. Looking at the 49-59 Ford Chassis Parts Catalog I only see the bolt and the wavy washer. I think the "D" shape in your parts is the result of modification and/or wear.

Bob C · 03-30-2023, 08:10 PM

Sponsored Links (Register now to hide all advertisements)

Here's a parts drawing.

03-27-2023, 05:42 AM	#1
fredeuce Member Join Date: May 2010 Location: South Australia Posts: 50	'53 Customline Clutch Push Rods I am going through the clutch pushrods on a '53 Customline. The bolts are stepped and use wave washers. The hole that the bolts are inserted into are "D" shaped. It all looks a bit odd. Is there meant to be a bush of some kind that goes into these rods? [IMG] [/IMG]

03-30-2023, 06:01 PM	#2
38 coupe Senior Member Join Date: May 2010 Location: South Texas Posts: 1,651	Re: '53 Customline Clutch Push Rods It has been too long since I had those parts off my car for memory. Looking at the 49-59 Ford Chassis Parts Catalog I only see the bolt and the wavy washer. I think the "D" shape in your parts is the result of modification and/or wear.