The Ford Barn

Terry, NJ · 10-01-2023, 02:50 PM

Just acquired a new (Sorta) Flywheel cover with these numbers and no visible cracks. It's rusty as hell and requires a lot of wire brushing. Who is/was REPUBLIC? Was Ford using this name for some reason ? Or was Ford subbing out some of the casting work?
Also, should I pay someone with a Blanchard or a Blanchard type grinder to kiss off the mating surfaces ? As I said, this thing is is rusty as hell and the mating, surfaces are are distorted. And parallelism ????????. How much can you take off a F W. cover safely ? Thanks in advance!
Terry

Flathead · 10-02-2023, 08:52 AM

Consider getting it blasted and be sure there are no cracks, especially around bolt holes for back of block. Be too bad to machine up a cracked housing, and they are prone to being cracked.

JayJay · 10-02-2023, 09:22 AM

Quote:

Originally Posted by Flathead

Consider getting it blasted and be sure there are no cracks, especially around bolt holes for back of block. Be too bad to machine up a cracked housing, and they are prone to being cracked.

Yup. I have three flywheel housings and the two that are presently off of cars are both cracked at the mounting holes. I don’t know about the one currently on the car. I do need two good ones for the two cars so I keep looking. In the meantime, the two bad ones make good practice for stamping numbers in engine blocks.

Big hammer · 10-02-2023, 10:15 AM

Sponsored Links (Register now to hide all advertisements)

Synder’s have in their online catalog a cast iron and aluminum flywheel housing 525 $ for either one. Most original housing are cracked, the latter ones are better as they have been beefed up as the new housing

10-01-2023, 02:50 PM	#1
Terry, NJ Senior Member Join Date: May 2010 Location: Bucks Co, Pa Posts: 3,740	Casting Numbers REPUBLIC B140 Flywheel cover Just acquired a new (Sorta) Flywheel cover with these numbers and no visible cracks. It's rusty as hell and requires a lot of wire brushing. Who is/was REPUBLIC? Was Ford using this name for some reason ? Or was Ford subbing out some of the casting work? Also, should I pay someone with a Blanchard or a Blanchard type grinder to kiss off the mating surfaces ? As I said, this thing is is rusty as hell and the mating, surfaces are are distorted. And parallelism ????????. How much can you take off a F W. cover safely ? Thanks in advance! Terry

10-02-2023, 08:52 AM	#2
Flathead Senior Member Join Date: May 2010 Location: Southern Maine Posts: 1,499	Re: Casting Numbers REPUBLIC B140 Flywheel cover Consider getting it blasted and be sure there are no cracks, especially around bolt holes for back of block. Be too bad to machine up a cracked housing, and they are prone to being cracked.

10-02-2023, 10:15 AM	#4
Big hammer Senior Member Join Date: Jun 2014 Location: Land of Lincoln Posts: 3,131	Re: Casting Numbers REPUBLIC B140 Flywheel cover Sponsored Links (Register now to hide all advertisements) Synder’s have in their online catalog a cast iron and aluminum flywheel housing 525 $ for either one. Most original housing are cracked, the latter ones are better as they have been beefed up as the new housing __________________ Don't force it with a little hammer tap, tap, tap get a bigger hammer tap done