|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-24-2010, 03:24 PM | #1 |
Junior Member
Join Date: May 2010
Location: Spring Texas
Posts: 7
|
1938 pickup spare tire rack
I have part of a spare tire holder, the verticle support that bolts down to the running board.I understand that there are additional brackets which I need, I was wondering if someone could give me a close-up picture of these in order for me to fabricate them. Thanks Joe
|
09-24-2010, 06:54 PM | #2 |
Senior Member
Join Date: May 2010
Location: Edgefield, SC
Posts: 810
|
Re: 1938 pickup spare tire rack
There is a spare mounting flange that would be difficult to fabricate as well as a top strap that would be difficult to fabricate. There is a stiffener that is strap like that would be easy to fabricate and a hollow rod that looks much like a piece of pie that would be easy to fabricate. If you email me at [email protected] I can email you pictures of the complete setup tomorrow morning. Be sure you have the correct rod like piece...the 35 is not the same, nor is the 36/7.
|
Sponsored Links (Register now to hide all advertisements) |
|
09-24-2010, 07:01 PM | #3 |
Senior Member
Join Date: May 2010
Location: Atlanta area
Posts: 833
|
Re: 1938 pickup spare tire rack
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|