|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-24-2013, 06:23 PM | #1 |
Senior Member
Join Date: May 2010
Location: Suth'N Maine
Posts: 1,996
|
As Plumb she be...
So Sat. with my guiding light's in Gardiner, we got talking about checking front/rear wheels, alignment ect. It was brought up that after I had set and got my rear spring into place to check my wheel center measurements in an "X" configuration.
This is how I did it. Centering a plumb on the outside of the wheel's and keeping it centered through the spindle's to the floor I marked all four wheel's. Next measured LF to RR and RF to LR I used the 1" mark on the front's and both readings were 131", actually 130". She passed the test |
03-24-2013, 08:44 PM | #2 |
Senior Member
Join Date: May 2010
Location: Gardiner Me.
Posts: 4,200
|
Re: As Plumb she be...
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|