|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-26-2014, 07:36 PM | #1 |
Senior Member
Join Date: May 2010
Location: Chester Vt
Posts: 8,861
|
Yransmission help
Hi Guys, Have this RTS 3 sp w/OD and can't get the shift cover off the trans to install it into the truck. Have it bolted on the engine and would like to put it in but the stick is in the way. Is there a way to rempve just the stick? I have all the bolts off the cover nad tried to pry it of like an old ford box bit I'm afraid to brake it. Thanks
|
05-26-2014, 09:02 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,755
|
Re: Yransmission help
I had to put mine in 2nd gear to get the cover off the trans.
Bob |
Sponsored Links (Register now to hide all advertisements) |
|
05-26-2014, 09:05 PM | #3 |
Senior Member
Join Date: May 2010
Location: Chester Vt
Posts: 8,861
|
Re: Yransmission help
Very interesting, thankyou. Have to go to the VA tomorrow and will try that when I get back.
|
05-26-2014, 10:23 PM | #4 |
Senior Member
Join Date: May 2010
Location: Brandon Mb Canada
Posts: 133
|
Re: Yransmission help
If you just need the lever off ,un screw the retaining cap and it pulls out, as does mine. Laurie
|
05-26-2014, 10:25 PM | #5 |
Senior Member
Join Date: May 2010
Location: Napier, New Zealand
Posts: 2,001
|
Re: Yransmission help
Mine too. I put mine in neutral, then unscrew the lever. It's hard to get back in if not in neutral. If you take the whole top off it's best in 2nd as someone else said.
|
05-27-2014, 05:55 AM | #6 |
Senior Member
Join Date: May 2010
Location: Chester Vt
Posts: 8,861
|
Re: Yransmission help
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|