The Ford Barn

spinelll · 04-23-2011, 08:23 PM

I was trying to install a second license plate bracket to house my 1930 antique plate but can't figure out how to get the wires out of the tail light. Do those light sockets push out the back of the housing? If not, how the heck do I thread the wires through the new bracket.

Mitch//pa · 04-23-2011, 09:53 PM

follow the wire harness down under the body behind the fender. the wires disconnect there

Mike V. Florida · 04-24-2011, 12:57 AM

Sponsored Links (Register now to hide all advertisements)

If I remember right, the connector is a rubber thing that the two bullet ends plug into.

04-23-2011, 09:53 PM	#2
Mitch//pa BANNED Join Date: May 2010 Location: Bucks County, PA Posts: 11,454	Re: Tail light disassembly follow the wire harness down under the body behind the fender. the wires disconnect there

04-24-2011, 12:57 AM	#3
Mike V. Florida Senior Member Join Date: May 2010 Location: South Florida Posts: 14,054	Re: Tail light disassembly Sponsored Links (Register now to hide all advertisements) If I remember right, the connector is a rubber thing that the two bullet ends plug into. __________________ What's right about America is that although we have a mess of problems, we have great capacity - intellect and resources - to do some thing about them. - Henry Ford II