|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-25-2024, 06:29 AM | #41 | |
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,521
|
Re: Pressurized center main bearing?
Quote:
In a nutshell, there really isn't a need to pressurize all three. The size of the rear main bearing is WAY more adequate than needed, and it receives plenty of oil thru gravity. If you were to pressurize the rear main, then you must figure out how to effectively, -and reliably seal the rear of the rear main to keep it from leaking oil out into the flywheel housing. The tubes that feed the mains are the same tubes as used for the horn rod and the center hood rod. They are a rolled tube that will leak if pressure is added. The camshaft oiling is not compromised. |
|
03-27-2024, 12:47 PM | #42 |
Senior Member
Join Date: Apr 2018
Location: Mebane NC
Posts: 2,358
|
Re: Pressurized center main bearing?
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|