Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-13-2010, 12:03 PM   #1
Gary in Mozarks
Senior Member
 
Gary in Mozarks's Avatar
 
Join Date: May 2010
Location: Vienna Mo
Posts: 232
Default Replacing axle seals 39 ford

I pulled the hubs off both of the rear ends I have and found that both of them had grease and oil all over the drums etc. Looks like its a common problem.

Any special tricks to replacing the rear axle seals?

Anything else I should do while I am in there?

Whats the procedure for pulling the rear axles out?


Side note, My new economy hub puller lasted through 3 hubs .
It looks like I pretty much stripped out the threads on one side of the hub puller on a really tight hub. Anyone else had one fail? I will probably rethread it to 1/2x20
Gary
Attached Images
File Type: jpg brakes 1.jpg (77.2 KB, 262 views)
File Type: jpg brakes 2.jpg (82.5 KB, 227 views)
Gary in Mozarks is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:25 PM.