|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-13-2010, 12:03 PM | #1 |
Senior Member
Join Date: May 2010
Location: Vienna Mo
Posts: 232
|
Replacing axle seals 39 ford
I pulled the hubs off both of the rear ends I have and found that both of them had grease and oil all over the drums etc. Looks like its a common problem.
Any special tricks to replacing the rear axle seals? Anything else I should do while I am in there? Whats the procedure for pulling the rear axles out? Side note, My new economy hub puller lasted through 3 hubs . It looks like I pretty much stripped out the threads on one side of the hub puller on a really tight hub. Anyone else had one fail? I will probably rethread it to 1/2x20 Gary |
|
|
Sponsored Links (Register now to hide all advertisements) |
|