|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
|
12-24-2011, 12:07 PM | #1 |
Senior Member
Join Date: May 2010
Location: Corona, CA
Posts: 185
|
Early Ford Tie Rod Ends
I did a search and came up with nothing so for the early Ford machinists out there - does anybody know the angle of the taper on an early ford ('40 - '48) tie rod end? Is a standard or special reamer available?
|
12-24-2011, 12:35 PM | #2 |
Senior Member
Join Date: May 2010
Location: NorCal
Posts: 2,617
|
Re: Early Ford Tie Rod Ends
7 degrees. Standard Ford taper
|
Sponsored Links (Register now to hide all advertisements) |
|
12-24-2011, 02:21 PM | #3 |
Member
Join Date: May 2010
Location: Torrance Ca.
Posts: 51
|
Re: Early Ford Tie Rod Ends
I've been using this one from Snap On for years... http://buy1.snapon.com/catalog/item....re&dir=catalog
|
12-24-2011, 03:08 PM | #4 |
Senior Member
Join Date: May 2010
Location: Corona, CA
Posts: 185
|
Re: Early Ford Tie Rod Ends
Thank you and Merry Christmas.
|
12-24-2011, 07:29 PM | #5 |
Senior Member
Join Date: May 2010
Location: Graham WA
Posts: 424
|
Re: Early Ford Tie Rod Ends
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|