|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-27-2011, 10:35 AM | #1 |
Senior Member
Join Date: Jul 2010
Location: Pottersville, NJ
Posts: 238
|
Rivet Installation / Air Hammer
I would like to replace the corner covers on my hood and the rubber parts that are riveted onto the hood.
I have this kit minus the yellow rivet tool. http://www.brattons.com/product.asp?...istory=related What size air hammer would work with the rivet installation kit I have? Would this one work?? http://cgi.ebay.com/ws/eBayISAPI.dll...m=170247118307 **1 5/8" stroke provides the power for general cutting chipping and scraping needs **At 5000 blows per minute provides the speed for fast exhaust removal and masonry **Built in power regulator to control speed during delicate usage **Designed to use with .401 Parker taper chisels Would the yellow rivet tool from Brattons work for what I want to do? I am not sure it would be deep enough. |
02-27-2011, 11:08 AM | #2 |
Senior Member
Join Date: May 2010
Location: Boston North Shore
Posts: 752
|
Re: Rivet Installation / Air Hammer
Bill,
Those can be some hard to get at areas. You might try this: http://www.aircraftspruce.com/catalo...etsqueezer.php Steve |
Sponsored Links (Register now to hide all advertisements) |
|
02-27-2011, 01:08 PM | #4 | |
Senior Member
Join Date: May 2010
Location: Ridgefield, Ct
Posts: 3,441
|
Re: Rivet Installation / Air Hammer
That is a "Must Have" item for work around finished paint.
Quote:
|
|
02-27-2011, 01:13 PM | #5 |
Senior Member
Join Date: May 2010
Location: Lakeville, MN
Posts: 5,168
|
Re: Rivet Installation / Air Hammer
Sponsored Links (Register now to hide all advertisements)
Rusty Nelson |
|
|
Sponsored Links (Register now to hide all advertisements) |
|