02-13-2011, 11:42 AM | #1 |
Senior Member
Join Date: Feb 2011
Location: Ohio
Posts: 419
|
cam id
Just started to degrease my cam and it has a letter K and number 29 on it don't know the history of this motor, and was wonder if it stock or some thing else. If u guys need more info that I don't know about tell me where to look and I'll do my best since I'm a rookie here. Thanks
|
02-13-2011, 01:08 PM | #2 |
Senior Member
Join Date: May 2010
Location: Sherman, CT
Posts: 330
|
Re: cam id
Hi 47 flatbed; What motor is the cam out of? Thanks, Craig.
|
Sponsored Links (Register now to hide all advertisements) |
|
02-13-2011, 02:18 PM | #3 |
Senior Member
Join Date: May 2010
Location: Northern California,coast
Posts: 552
|
Re: cam id
HEY 47: Where are the numbers, and are they stamped or cast, is the main shaft machined between lobs or with cast markings?? The lobes, how tall and thick at the base ( not wide ) The top of the lobe, is smooth round roll over, or is it peaked,with very little flat at top ??... Pictures, lots of pictures .
And a WARM WELCOME to the newbee. (rookie).... OLD....BILL |
02-13-2011, 06:19 PM | #4 |
Senior Member
Join Date: Feb 2011
Location: Ohio
Posts: 419
|
Re: cam id
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|