|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-11-2013, 11:06 AM | #1 |
Junior Member
Join Date: Nov 2011
Location: State of Jefferson
Posts: 21
|
Installing outside Zinc running board strip
This may have been covered before, but my search didn't get what I need Any recommendations (maybe a tool/jig?) for bending the zinc outside running board strip? I don't wanna mess up those shiny, straight repros. This is late '30 commercial, no rivets. Thanks so much for any suggestions.
|
04-11-2013, 12:05 PM | #2 |
Senior Member
Join Date: May 2010
Location: Lakeville, MN
Posts: 5,165
|
Re: Installing outside Zinc running board strip
I made a response to a post a while back. Go to:
https://www.fordbarn.com/forum/showthread.php?t=102369 Rusty Nelson |
Sponsored Links (Register now to hide all advertisements) |
|
04-11-2013, 10:28 PM | #3 |
Junior Member
Join Date: Nov 2011
Location: State of Jefferson
Posts: 21
|
Re: Installing outside Zinc running board strip
Thanks Rusty, Just what I was looking for. Guess I used the wrong words in my search. That is really helpful and on the list for this weekend... if I can just squeeze under there... it used to be so simple!
|
04-12-2013, 03:03 AM | #4 |
Senior Member
Join Date: Oct 2011
Location: Coastal Mississippi & Central West Florida
Posts: 206
|
Re: Installing outside Zinc running board strip
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|