|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-13-2013, 04:49 PM | #1 |
Member
Join Date: Jun 2013
Location: Tyrone, Pa.
Posts: 89
|
Coil... Labeled: "dist" is that the plus side?
I have the wiring diagram right in front of me, but I want to know which side of the coil is plus & minus? It only says on one side "dist"! Is the "dist" side plus or minus? Thank you!
Last edited by Doot; 06-13-2013 at 04:55 PM. Reason: Spelling |
06-13-2013, 05:13 PM | #2 |
Senior Member
Join Date: May 2010
Location: Young Harris, GA
Posts: 1,821
|
Re: Coil... Labeled: "dist" is that the plus side?
Dist will be the negative post. It assumes a modern negative ground system.
Is your car positive ground or negative ground?
__________________
Jim Cannon Former MAFCA Technical Director "Have a Model A day!" |
Sponsored Links (Register now to hide all advertisements) |
|
06-13-2013, 05:15 PM | #3 |
Member
Join Date: Jun 2013
Location: Tyrone, Pa.
Posts: 89
|
Re: Coil... Labeled: "dist" is that the plus side?
The positive battery cable from battery is on the frame...
|
06-13-2013, 06:14 PM | #4 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,751
|
Re: Coil... Labeled: "dist" is that the plus side?
Here is a link Tom posted on determining correct coil polarity.
http://www.chicagolandmgclub.com/tec...neral/574.html Bob |
06-13-2013, 06:31 PM | #5 | |
Member
Join Date: Jun 2013
Location: Tyrone, Pa.
Posts: 89
|
Re: Coil... Labeled: "dist" is that the plus side?
Quote:
A coil has a positive and negative post regardless if they labeled "dist" or not! I know your link suggested that from the factory they might not know which side is which, but I have to disagree! There is no way Henry Ford would not have distinguished the polarity of his coils for the common man back in the day!!! My car is All original and I can't find the literature for polarity directly from the factory..... It's not a matter of a running/car issue, I just want to KNOW for myself! I appreciate the info you have given me thus far, and want you to know you are helping!!! Thank you! |
|
06-13-2013, 07:12 PM | #6 |
Senior Member
Join Date: May 2010
Location: Englewood, Colorado
Posts: 1,372
|
Re: Coil... Labeled: "dist" is that the plus side?
Sponsored Links (Register now to hide all advertisements)
|
06-13-2013, 07:39 PM | #7 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Coil... Labeled: "dist" is that the plus side?
Any coil that is marked DIST and BAT is totally meaningless, unless you know the specific car that coil was made for and which battery post was ground on that car.
I wish all coils simply had a + and - marking, then there would be no guesswork, as the battery ground should be that same as the marking that goes to the points. Positive battery ground means + on the coil goes to the points. |
06-13-2013, 07:58 PM | #8 |
Member
Join Date: Jun 2013
Location: Tyrone, Pa.
Posts: 89
|
Re: Coil... Labeled: "dist" is that the plus side?
Okay to all participants! I will do the necessary tests you mentioned and go from there! Thank you! I will keep you posted!!! Thank you
|
06-13-2013, 08:09 PM | #9 |
Member
Join Date: Jun 2013
Location: Tyrone, Pa.
Posts: 89
|
Re: Coil... Labeled: "dist" is that the plus side?
Here's the diagram I am using... Just wasn't sure which terminal to use off the coil... I think you nailed it!
|
06-13-2013, 08:18 PM | #10 | |
Member
Join Date: Jun 2013
Location: Tyrone, Pa.
Posts: 89
|
Re: Coil... Labeled: "dist" is that the plus side?
Quote:
Hopefully this pic came out straight up and down? |
|
06-14-2013, 01:59 AM | #11 |
Member
Join Date: Jun 2013
Location: Tyrone, Pa.
Posts: 89
|
Re: Coil... Labeled: "dist" is that the plus side?
Okay... Forget about this thread.... Got that question fixed... Went through wiring diagram and all wires are now correct!.
See new thread... |
06-14-2013, 03:47 AM | #12 |
Senior Member
Join Date: Nov 2012
Location: Tauranga, New Zealand
Posts: 726
|
Re: Coil... Labeled: "dist" is that the plus side?
Doot, If a coil is marked "Dist" Then that side is wired to the distributor. The other side goes to the feed or ignition switch. The coil can be used in a negative to earth or a positive to earth system. The coil is not polarity sensitive. It is the way it is wired inside, that decides which side is the "Breaker" side or "feed" side.
I have posted, hopefully to help others following this thread. |
06-14-2013, 04:21 AM | #13 |
Senior Member
Join Date: Jul 2010
Location: United Kingdom
Posts: 1,442
|
Re: Coil... Labeled: "dist" is that the plus side?
. Yeah that's right if it's the correct coil and if the polarity of the car ground hasn't been changed. As others have pointed out the only way to be sure is to follow the guidance they've given. ( er, to be honest though on the A I found that an incorrectly wired coil still works OK!)
|
06-14-2013, 04:58 AM | #14 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Coil... Labeled: "dist" is that the plus side?
Yes, as John said, the car will start just fine either way the coil is wired. When the polarity makes a difference is when you need every bit of the available spark, such as running a higher compression head and flooring the throttle, then the spark plugs fire easier if the hot center electrode is NEGATIVE, as explained in the excellent short read by the Chicagoland MG club. It's well worth reading.
As I said earlier, the DIST label is meaningless unless you are using the coil on the car it was labelled for. Almost every Model A I see has a replacement coil, rather than the original coil with it's spot welded mounting bracket. That how I've been able to find so many good original coils at swap meets. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|