|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-29-2014, 04:08 PM | #1 |
Senior Member
Join Date: Oct 2010
Location: Orem, Utah
Posts: 5,762
|
How has anyone delt with this zerk problem?
47 sedan U-joint zerk. It's a 90° fitting but is too close to the frame member to get a grease gun onto.
I've tried to find a little elbow that would screw in its place that I could put a tube on to extend it beyond the frame member but haven't found one. Anyone else had this problem and found a solution?
__________________
Prof. Henry (The Roaming Gnome) "It is good to have an end to journey toward; but it is the journey that matters, in the end.” *Ursula K. Le Guin in The Left Hand of Darkness Last edited by Old Henry; 03-31-2014 at 03:35 PM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|