|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-13-2013, 08:02 PM | #1 |
Senior Member
Join Date: May 2010
Location: Bismarck ND
Posts: 1,189
|
Rear valance panel
I have a rear valance panel that goes between the fenders below the rear subframe. It says 31 on it. I have not spent much time with enclosed cars except for an A400 that I recently sold. This panel looks thinner than the A400. What cars used the valance panel. I have seen some on a Vicky but again this looks thinner (top to bottom). Could it be from a 4 dr sedan? Anyone need it?
Thanks |
12-14-2013, 01:01 AM | #2 |
Senior Member
Join Date: May 2010
Posts: 572
|
Re: Rear valance panel
The rear valance on the Victoria is different from that of the A400 or the deluxe phaeton. If you could post a photo of the panel, it can probably be identified.
|
Sponsored Links (Register now to hide all advertisements) |
|
12-16-2013, 11:32 PM | #3 |
Senior Member
Join Date: May 2010
Location: Bismarck ND
Posts: 1,189
|
Re: Rear valance panel
Sorry this took so long. I am not good with pictures. The first picture is the valance and the second is an iron piece that was attached to the valance when found. Any help is appreciated. If you need these parts just ask they are not in my future needs.
|
12-16-2013, 11:59 PM | #4 |
Senior Member
Join Date: May 2010
Posts: 3,099
|
Re: Rear valance panel
That appears to be for Murray bodied Fordor models from the beginning about February 1929 to early '31 when they were replaced with the slant windshield models. I have no clue what the added bracket was intended for.
__________________
http://www.abarnyard.com/ |
12-17-2013, 12:41 AM | #5 |
Senior Member
Join Date: May 2010
Location: Bismarck ND
Posts: 1,189
|
Re: Rear valance panel
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|