|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-06-2015, 07:09 PM | #1 |
Senior Member
Join Date: Oct 2011
Location: Falmouth, Ma.
Posts: 313
|
re seating of needle valve?
i have read about lengthening an old needle valve and then putting it in a drill and then using it to hone out the carburetor casting where the needle valve sits. is this actually possible? when i turn the gas adjustment valve all the way in it has little or no affect. this carb does not have a needle seat that is replaceable. thanks.
|
08-06-2015, 09:48 PM | #2 |
Senior Member
Join Date: May 2010
Location: toledo,ohio
Posts: 171
|
Re: re seating of needle valve?
gino; is your needle way worn? ive had similar issue. worn needle...kev
|
Sponsored Links (Register now to hide all advertisements) |
|
08-06-2015, 11:10 PM | #3 |
Senior Member
Join Date: May 2010
Location: Southern California
Posts: 3,131
|
Re: re seating of needle valve?
I suspect your problem is not the needle valve, but jets that are the wrong size. most reproduction jets on the market are an incorrect size due to quality issues. Many originals have been molested by people pushing welding tip cleaners through them.
The jets should be flow tested to determine they are within specs. If the comp jet is larger than the cap jet it renders the GAV control useless. Most of the time the GAV is cracked open a half to three quarters of a turn, so the seat is not a factor. I would obtain a set of flow tested jets. It will make a big difference in Carburetor performance and give you GAV control. Tom Endy |
08-07-2015, 07:08 AM | #4 |
Senior Member
Join Date: Oct 2011
Location: Falmouth, Ma.
Posts: 313
|
Re: re seating of needle valve?
I have heard of flow tested jets, I will ask Snyders about such. Kevin, areyou are asking about the natural needle seat in the casting? Thanks guys
|
08-07-2015, 04:11 PM | #5 |
Senior Member
Join Date: May 2010
Location: new britain,ct 06052
Posts: 9,390
|
Re: re seating of needle valve?
Gino: google Renner's Corner for the jets.
Paul in CT |
08-07-2015, 07:39 PM | #6 |
Senior Member
Join Date: Oct 2011
Location: Falmouth, Ma.
Posts: 313
|
Re: re seating of needle valve?
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|