'51 o/d cable holder

[Shoebox]

My '51 Tudor was not an O/D car originally but it is getting one now after Mac Vanpelt built me a trans. One piece I am lacking is the bracket or holder that secures the cable housing from moving at the transmission end, I believe it uses one of the tranny side cover bolts? I did this swap on a previous '51 but I can't remember the details. Any details (or a picture!) most appreciated.


Thanks!

[pistonbroke]

It goes on one of the solenoid bolts and I believe I have a spare if you can't find on ,Tim

[Shoebox]

Originally Posted by pistonbroke

It goes on one of the solenoid bolts and I believe I have a spare if you can't find on ,Tim

Tim, if you do have one I would be grateful if I could get that from you for whatever you need for it. Thanks.

[rotorwrench]

I can't speak on the Fords but my 51 Mercury has a tapped bolt hole above and centered between the shift arms on the side cover where a bolt and clamp attach to secure the cable housing.

[pistonbroke]

Yes , I will go looking this morning. We are still getting things organized after moving 2200 miles east and having my shop built last year. So it may take some searching. Tim.

[Shoebox]

Sponsored Links (Register now to hide all advertisements)

Tim, I certainly understand, will wait to hear from ya. Thanks much.


Scott

[pistonbroke]

Hey Scott, I found it . PM me and I'll send it. I'm down in Perry MO. just outside Hannibal. Should take about three days to get to you. Tim

[Shoebox]

Tim, Thank you so much! PM sent.