Need directional light WIREING diagram 6v pos ground

[josh1331]

Diagram needed for electric novice who hasn't the slightest idea of electric WIREING. Your assistance would be most appreciated. John.

[Andy]

Some more info would be helpful. What year vehicle? Stock wiring? Are you going to use a add on turn signal switch. There are small transisterized switches. The switches usually come with diagrams on where to cut and ad the wires. I use relays and a subminiture center off switch.

[JSeery]

As Andy said, you first need to decide what you are going to use to activate the turn signals. I, like Andy use a switch setup because I'm not a fan of the add on selectors on the column. But they are the easiest way to go. I would suggest you decide on a selector, order it and then if you don't understand the instructions that comes with it ask a question. If you are interested in a switch setup I can provide you that information. It is not difficult, but takes a little more effort than an add-on.

[BILL WZOREK]

Not trying to steal this thread only Borrow it for a bit !!!

Jseery I would be interested in a switch set up { how does it work }
[ I don't mean how well it works ]

[JSeery]

These diagrams are not mine, copied for others. There is a lot of good information at the site: http://www.how-to-build-hotrods.com/hot-rod-wiring.html

[Ralph Moore]

Sponsored Links (Register now to hide all advertisements)

I used these diagrams, not too hard to install, conversion box was not expensive from my local trailer store.

[josh1331]

Thank you all for input for my 1941 ford coupeSD . Diagrams for switch instal are great also.