|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-04-2011, 09:04 PM | #1 |
Junior Member
Join Date: Feb 2011
Posts: 19
|
41 Tudor rear fender welt how far?
Just about to install my rear fenders with new fender welt need to know wear the welting is suposed to stop or does it run the full length of the fender??
|
03-05-2011, 01:48 PM | #2 |
Junior Member
Join Date: Feb 2011
Posts: 19
|
Re: 41 Tudor rear fender welt how far?
Does any one know?
|
Sponsored Links (Register now to hide all advertisements) |
|
03-05-2011, 03:11 PM | #3 |
Senior Member
Join Date: May 2010
Location: Indianapolis
Posts: 250
|
Re: 41 Tudor rear fender welt how far?
According to photos in The V-8 Affair it looks like it stops at the flare over the running board. And obviously at the rear, it stops at the trunk opening. (That's based on the available photos which are all coupes).
|
03-05-2011, 06:20 PM | #4 |
Junior Member
Join Date: Feb 2011
Posts: 19
|
Re: 41 Tudor rear fender welt how far?
OK Dale
I know it ran from the Running boards up and over the fender but I didnt know if it stopped at the Trunk or not? I was thinking about running it all the way down past and thru into the Bumper cut out because I wasnt sure. At this point I guess I will run it from running board too trunk edge unless anyone else disagree's? |
03-05-2011, 07:07 PM | #5 |
Senior Member
Join Date: May 2010
Location: Indianapolis
Posts: 250
|
Re: 41 Tudor rear fender welt how far?
The pictures definetley show no welt running vertically down the trunk opening edge. Unfortunately, there is no clear view of the joint between fender and the panel under the trunk. There is a joint there which I would assume (dangerous word) would have welt in it.
|
03-06-2011, 07:02 AM | #6 |
Junior Member
Join Date: Feb 2011
Posts: 19
|
Re: 41 Tudor rear fender welt how far?
Sponsored Links (Register now to hide all advertisements)
I also think it would look funny there too running along side the edge of the trunk and the fender. |
03-06-2011, 03:23 PM | #7 |
Senior Member
Join Date: May 2010
Location: Pell City (New London) Al
Posts: 317
|
Re: 41 Tudor rear fender welt how far?
Oh well! Mine runs along the trunk lid and under the bumper bracket rubber. I don't know if it's correct,but it does look neat. Restored about 30 years ago. Good luck and I think it would look good either way.-Bill
|
03-06-2011, 03:27 PM | #8 |
Senior Member
Join Date: May 2010
Location: Pell City (New London) Al
Posts: 317
|
Re: 41 Tudor rear fender welt how far?
Forgot to mention that mine is a Tudor.
|
03-06-2011, 09:43 PM | #9 |
Junior Member
Join Date: Feb 2011
Posts: 19
|
Re: 41 Tudor rear fender welt how far?
Thank you Bill I appreciate that info
Any way you can post a picture of it? I started out working on it today and ended up going to an estate auction with a few old fords and a lot of old Ford parts I didnt get much but a bunch of guys got some killer deals. Wish I knew i knew about it earlier |
|
|
Sponsored Links (Register now to hide all advertisements) |
|