|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-16-2012, 10:09 AM | #1 |
Senior Member
Join Date: May 2010
Location: Vt
Posts: 231
|
clutch installation grease ?
When putting the clutch back together should a thin smear of grease be applied to the throw out bearing face and clutch fingers? Any suggestions? Thanks guys.
|
06-16-2012, 10:17 AM | #2 |
Member
Join Date: May 2010
Location: Chapel Hill, NC
Posts: 94
|
Re: clutch installation grease ?
I didn't put any grease on the clutch fingers or bearing face, and only a *very slight film* of high-temp grease on the shaft of the main bearing retainer that the throwout bearing rides on.
|
Sponsored Links (Register now to hide all advertisements) |
|
06-16-2012, 04:09 PM | #3 |
Senior Member
Join Date: May 2010
Location: Wheaton, IL (west chicago)
Posts: 558
|
Re: clutch installation grease ?
I did very slight film of lubriplate high temp grease on the the shaft, the fingers, and inside the hole.
All of the above pertains to the clutch parts you perverts
__________________
36 1/2 ton pickup on 38 car frame with 1940 v8 24 stud |
06-16-2012, 04:27 PM | #4 |
Senior Member
Join Date: Nov 2010
Location: Nottawa MI
Posts: 289
|
Re: clutch installation grease ?
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|