05-02-2012, 06:38 PM | #141 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
John, they (the lunch hours) are as long, or as short, as I need them to be... LOL Vic
__________________
Imagination is more important than knowledge. |
05-02-2012, 11:25 PM | #142 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 3,277
|
Re: What I Did on My Lunch Hour
|
Sponsored Links (Register now to hide all advertisements) |
|
05-03-2012, 05:58 AM | #143 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
Thanks Ken, I appreciate that and may be contacting you once we open her up! Besides, I could use another road trip... Vic
__________________
Imagination is more important than knowledge. |
05-03-2012, 10:19 AM | #144 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
Wow, the Postman just delivered a package with spark plug wires and Rajah Caps for the Zephyr and just in time for lunch... Now for some more fun...
__________________
Imagination is more important than knowledge. |
05-03-2012, 06:41 PM | #145 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
I'm takin' a short cut... I have an original spark plug wire loom from a '39 LZ that was found in a Lincoln Dealership years ago by a friend of mine. Apparently Lincoln dealerships replaced the entire wiring harness (already installed in the looms along with the generator, voltage regulator and water temp wire harness). Well, as you can imagine, the wires are dry rotted however they are the correct length so, I pulled each one out and labeled it in order to measure and cut the new wires... I hope it works, we'll see.
__________________
Imagination is more important than knowledge. |
05-04-2012, 11:54 AM | #146 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
Sponsored Links (Register now to hide all advertisements)
__________________
Imagination is more important than knowledge. |
05-04-2012, 06:35 PM | #147 |
Senior Member
Join Date: Mar 2011
Location: W. Mich.
Posts: 486
|
Re: What I Did on My Lunch Hour
I just caught the Zephyr saga. You sure had your share of gremlins in it. It was probably a good thing to put the Columbia on hold until you could go through it. Then you'll be confident that it is done right & ready to roll. I like you collection & the fact that you never seem to tire of the challenges.
|
05-04-2012, 08:28 PM | #148 | |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
Quote:
__________________
Imagination is more important than knowledge. |
|
05-05-2012, 04:50 AM | #149 | |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 3,277
|
Re: What I Did on My Lunch Hour
Quote:
|
|
05-05-2012, 10:11 AM | #150 |
Member
Join Date: May 2010
Posts: 42
|
Re: What I Did on My Lunch Hour
Smaller diameter tubes used before 1941. Drivers side tubes are 29" in length and passenger side tubes are 26" in length.
Larger diameter tubes were used from 1941 on in response to added wireing for B-W overdrive transmission and new glass bowl fuel pump which required a shorter driver side tube to keep from interferring with new fuel pump. Both side tubes are 26" in length. |
05-05-2012, 02:41 PM | #151 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
Copperpenny,
Thanks for that information. Here are a few photos of the two different looms. This is the “later” set with the large opening in the rear. And this is the set of looms that were in the trunk of the ’39 Zephyr when I got her. You can see my handy work with the plug wires, etc.
__________________
Imagination is more important than knowledge. |
05-06-2012, 11:35 AM | #152 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
A Big THANKS to Shelly & Mac VanPelt
The other day I got the plug wire that I ordered from the Hot Rod Company, along with the Rajah ends for the plugs, they didn't have the correct end caps for the distributor... So, I went up to the local auto parts store as well as NAPA and they told me that they only sell complete plug wire sets... I called Mac; Shelly told me they had the 7mm ends for the distributor. I need 12 to do the LZ but asked Shelly to send 16 because I know I'll most likely mess up one or two installing them... Thanks again, Vic
__________________
Imagination is more important than knowledge. |
05-07-2012, 06:39 AM | #153 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
This past Saturday I drove the LZ up to the "Hot Rod Breakfast Club", her first extended outing with everything back together, she ran cool with steady, albeit, low oil pressure and did not skip a beat. The round trip is just less than 130 miles mostly on open highway. When I got home I changed the oil & filter, cleaned the heads and applied a coat of Bill Hirsh Lincoln green paint to them. Next up, we'll pull the distributor to install the new gasket set and install the looms with the new plug wires.
__________________
Imagination is more important than knowledge. |
05-08-2012, 06:52 PM | #154 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
I backed the Zephyr out of the garage this morning and noticed an accumulation of liquid on the floor directly under where the passenger side water pump was parked. I got out of the car and did the smell test as the water had the essence of cooling system orange coloring but with a little oil added to it. I suspect that the passenger side water pump is leaking where it butts up to the block because the hoses and clamps are relatively new and tight. The Zephyr water pumps are the externally oiled type, and clean oil mixed with orange (rust colored) water dripping down the lower radiator hose (it is almost impossible to see anything leaking to determine the origin of the leak) is a strong indication that the water pump is leaking. I guess I'll pull both pumps off and send them to Skip but I really wanted to install the plug wire looms and drive the car a little first. What is the consensus with respect to adding some sort of stop leak to the cooling system (the car is running cool) as an alternative to removing the pumps right away...
__________________
Imagination is more important than knowledge. |
05-08-2012, 09:30 PM | #155 |
Senior Member
Join Date: May 2010
Location: Ft Mohave,Az
Posts: 1,990
|
Re: What I Did on My Lunch Hour
Vic is it possible to find a couple of spare pumps to send to Skip? That way you could drive around & it wouldn't take long to change out the rebuilt ones. Less down time.
|
05-08-2012, 09:40 PM | #156 | |
Senior Member
Join Date: May 2010
Location: Above the gnat line in Georgia
Posts: 7,009
|
Re: What I Did on My Lunch Hour
Quote:
|
|
05-08-2012, 09:48 PM | #157 |
Senior Member
Join Date: May 2010
Location: Ft Mohave,Az
Posts: 1,990
|
Re: What I Did on My Lunch Hour
Vic;
Don't know if these are what you but on evil bay for cheep. Item number: 190676307915 |
05-08-2012, 11:43 PM | #158 |
Senior Member
Join Date: Jul 2010
Location: Queen Creek AZ
Posts: 519
|
Re: What I Did on My Lunch Hour
Sound like you have one of the original carbon seal failing on you and leaking out from the pourous bushing which are known to leak after a while. Skips rebuild water pumps are the best and using a seal bearing and you do not have to put oil in the upright oillers they will be there for look only. Vic when I did my spark plug wire loom I build a template with a piece of 3/4 plywood and bolted it down so that it would be more stable to feed all of the wires through then I removed the wire loom tube from the fixture and installed it back on the motor very easy to do.
Frenchy |
05-09-2012, 06:08 AM | #159 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
Knowing that everything is relative, I checked and rechecked the hose and clamps. Unfortunately, it is the pump that is leaking... Oh well, another project...
__________________
Imagination is more important than knowledge. |
05-09-2012, 06:10 AM | #160 |
Senior Member
Join Date: May 2010
Location: Odessa, FL
Posts: 7,611
|
Re: What I Did on My Lunch Hour
Thanks B-O-B, I checked those out... I think I'll just have Skip rebuild the ones I've got.
__________________
Imagination is more important than knowledge. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|