|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Posts: 4,581
|
![]()
Anyone have a good picture of the 32-34 truck map pocket that was on the right kick panel? Le Barron used to show them in their catalogue but I don't know if anyone is doing them currently. I am helping a friend gather parts for his 32 BB short wheelbase stake bed.
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: NJ
Posts: 6,275
|
![]()
Is this a folded and angled sheet metal thing? If so, I think I have one on my garage and can get pictures later this afternoon.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,821
|
![]()
This is for AA, may be the same.
https://www.snydersantiqueauto.com/s...ispatch+pocket |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2010
Location: NJ
Posts: 6,275
|
![]()
The one I have is similar to what Bob C has. I was told it came from a '34 truck.
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2015
Posts: 8,579
|
![]()
__________________
The only thing nice about being imperfect is the joy it brings to others.... "Silver rings, your butt! Them's washers!" "We shot our way out of that town for a dollar's worth of steel holes!" - from 'The Wild Bunch' - 1969 https://www.youtube.com/watch?v=7NReUd2_0u0 |
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: May 2010
Posts: 4,581
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: May 2010
Location: Yucaipa, CA
Posts: 1,114
|
![]()
I have a basket case '34 firetruck hose tender that still has its original map pouch in it. It looks basically centered from front to back on the kick panel. The bottom rivet (closest to the door) is 8 5/8" from the metal floor edge of the cab to the center of the rivet. The top rivet (the one closest to the door is 12 1/2" from the floor to the center of the rivet. I'd send a photo, but I had a stroke, and I can't get pictures out of my phone yet. I can email them; I just can't get them to go to my computer. There are screws holding the kick panel on. The fourth screw from the bottom of the kick panel lines up with the top corner of the box (not the rivet hole). Judging by the screws holding the kick panel on that AA photo posted, my '34 is mounted just a little bit higher approximately 1/2"??? I'd say from inside corner of the top bend it's a straight line over to the bottom of the of the #4 kick panel screw.
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|