|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Member
Join Date: Mar 2022
Posts: 37
|
![]()
Have t-5 setup for 1953 flathead pickup engine. Clutch wont disengage. Did some measurements and t-5 trans shaft is only 1/4 inch from raised center on clutch disk. Theirs plenty of depth for pilot bearing shaft. Im thinking clutch is hitting trans shaft and wont disengage. Pressure plate is 10 1/2 1800 lb and 10 1/2 clutch disc. All from speedway. no help from speedway. Is their another clutch disk that would give more clearance?
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Midland Park, NJ
Posts: 4,009
|
![]() Sponsored Links (Register now to hide all advertisements)
__________________
48 Ford Conv 56 Tbird 54 Ford Victoria |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|