|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-25-2013, 06:32 PM | #11 |
Senior Member
Join Date: Dec 2010
Location: pittsburgh pa
Posts: 576
|
Re: 30 Coupe. Gonna Have To Raise the Dead
bead roller ,a break and a shrinker was used to make that piece . not to much involved in that panel honestly . roll your bead ,break the vertical edge and then hammer form the bottom break .
got my hands on one of the nicest decklids i have seen in a long time !! now to make it fit !
__________________
Please call or email while website is down! 412 867 1659 [email protected] https://www.facebook.com/flop.custom |
|
|
Sponsored Links (Register now to hide all advertisements) |
|