The Ford Barn

Vanspeed · 04-23-2012, 07:48 PM

I took my zenith apart again to drill out the old plugs, clean the passageways and put new plugs in. My kit came with three small plugs and one big. I can only find three plugs. Do you drill out the hole completely? Snyders catalog calls for using an 1/8 inch bit. Last question is about my float. When I took the carb off, I had about 1/4 of gas in the carb. Is this right? I ran it a couple days ago and shut it off before closing the shutoff valve, I never run A's dry. Also, no gas dripped from the line at all. Sorry for the questions but hopefully you can help.

04-23-2012, 07:48 PM	#1
Vanspeed Senior Member Join Date: May 2010 Location: Suttons Bay, Mich. Posts: 3,392	Some zenith questions I took my zenith apart again to drill out the old plugs, clean the passageways and put new plugs in. My kit came with three small plugs and one big. I can only find three plugs. Do you drill out the hole completely? Snyders catalog calls for using an 1/8 inch bit. Last question is about my float. When I took the carb off, I had about 1/4 of gas in the carb. Is this right? I ran it a couple days ago and shut it off before closing the shutoff valve, I never run A's dry. Also, no gas dripped from the line at all. Sorry for the questions but hopefully you can help. __________________ *Respecting and Resurrecting Ford Model A's.*