|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
12-13-2011, 10:49 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Las Vegas, NV
Posts: 213
|
Math for valve to head clearance?
Offy heads with valve pockets .425" deep, compressed copper gasket .062" and net lift .361"; the math says I should have valve to head clearance of .126". When I clay I get .090". Have I left something out in my calculations? My valve pocket depth varies; should it be uniform all around or is the pocket cut on an angle? When I clayed I did so at the .425 depth.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:54 AM.