|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-27-2013, 04:15 AM | #1 |
Senior Member
Join Date: Sep 2010
Location: South Coast NSW Australia
Posts: 2,596
|
1 more 28 CCPU ID part
Have these 4 parts.. 2 are 17 inches long and 2 are 16 inches long, 3 holes each,
I have searched thru Brattons pics and cannot find them. The 17 inch long looks about right for a for-aft floorboard fit. Dunno what it would do there...maybe hold a rubber mat in place? Any ideas? |
02-27-2013, 07:05 AM | #2 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,934
|
Re: 1 more 28 CCPU ID part
These are the two pieces that go to the front and rear of the door glass. They are for the three sided piece of "moulding" that covers the inside of the window frame to slide down on from the top. When installed the screws have to have a bit of a loose fit to allow it room to slide. You can tighten the lowest screw a bit more just before it is covered by the moulding piece. I can't remember if the long piece is to the front or the rear.
Dave
__________________
Dave / Lincoln Nebraska |
Sponsored Links (Register now to hide all advertisements) |
|
02-27-2013, 09:24 AM | #3 |
Senior Member
Join Date: May 2010
Location: Boulder, CO
Posts: 559
|
Re: 1 more 28 CCPU ID part
Here is a picture showing the side window trim and slide for the 82-A cab.
|
02-27-2013, 01:12 PM | #4 |
Senior Member
Join Date: Sep 2010
Location: South Coast NSW Australia
Posts: 2,596
|
Re: 1 more 28 CCPU ID part
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|