|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-11-2018, 05:42 PM | #1 |
Senior Member
Join Date: May 2010
Location: Rathdrum Idaho
Posts: 737
|
40 Ford coupe door garnish
Does anyone know what size,kind, and where to locate the rivets for the door garnish rubber and wing lock on a 40 coupe? Are these hollow tubular? Also how are they set? is there a special pair of pliers or use a punch? How about the wing window pivot?
|
11-11-2018, 06:06 PM | #2 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 11,006
|
Re: 40 Ford coupe door garnish
I remember years ago I used large pop rivets with pop rivet washers. Still holding after 40 years.
|
Sponsored Links (Register now to hide all advertisements) |
|
11-11-2018, 06:11 PM | #3 | |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 9,068
|
Re: 40 Ford coupe door garnish
Sponsored Links (Register now to hide all advertisements)
Quote:
The rivets that go through the rubber: I use a small carriage bolt, a #10 as I recall, and a lock washer and nut on the reverse of the molding.
__________________
"I can explain it for you. However, I can't understand it for you". |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|