|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
05-22-2015, 06:48 PM
|
#1 |
|
Member
Join Date: Jun 2010
Location: Perryton
Posts: 69
|
Aluminum Fan Blade Issue
I have placed a new aluminum fan blade on. I have tightened the nut and placed the cotter key in. I ran the engine on a 10 mile test drive. I had to tightened the nut again. I was wondering if I should put a washer behind the nut to put it at the correct alignment for the cotter pin. I would appreciate any help.
Thanks. |
|
|
|
05-22-2015, 06:54 PM
|
#2 |
|
Senior Member
Join Date: Mar 2013
Location: Australa Melbourne
Posts: 878
|
Re: Aluminum Fan Blade Issue
Yes I put a stainless washer there
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
05-22-2015, 06:56 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,300
|
Re: Aluminum Fan Blade Issue
A thin ss flat washer will help prevent the nut from eroding the face of the aluminum casting.
|
|
|
|
05-22-2015, 08:33 PM
|
#4 |
|
Member
Join Date: Jun 2010
Location: Perryton
Posts: 69
|
Re: Aluminum Fan Blade Issue
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:22 PM.