|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-16-2012, 04:59 PM | #1 |
Senior Member
Join Date: May 2010
Location: Denville NJ
Posts: 964
|
ignition cable threads
Can someone tell me what the correct size tap is for the ignition cable into the distributor? I have a dizy I rebuilt, but the pop out cable will not thread into the housing. I need to clean the threads. Thanks, Ed Saniewski
__________________
Model A Ford Club of New Jersey http://www.mafcnj.org Model A Pick Up Owners and Enthusiasts https://www.fordbarn.com/forum/group.php?groupid=5 |
09-16-2012, 05:25 PM | #2 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: ignition cable threads
I seem to recall it's 1/2" pipe thread. If not, then it was 3/8" pipe thread.
If you don't have a tap then you can use a hacksaw to cut 4 slits in a short piece of pipe to use as a thread cleaner. |
Sponsored Links (Register now to hide all advertisements) |
|
09-17-2012, 05:28 AM | #3 |
Senior Member
Join Date: May 2010
Location: Denville NJ
Posts: 964
|
Re: ignition cable threads
Sponsored Links (Register now to hide all advertisements)
__________________
Model A Ford Club of New Jersey http://www.mafcnj.org Model A Pick Up Owners and Enthusiasts https://www.fordbarn.com/forum/group.php?groupid=5 |
|
|
Sponsored Links (Register now to hide all advertisements) |
|