Thread: H&H Flatheads
View Single Post
Old 07-01-2011, 03:47 PM   #9
Ronnie
Senior Member
 
Ronnie's Avatar
 
Join Date: May 2010
Location: Canada Where it snows
Posts: 2,058
Default Re: H&H Flatheads

Quote:
Originally Posted by dschwartz View Post
Beware of H&H Flatheads.
I Dan Schwartz bought from Jody Martin a 59AB block that was repaired and machine by H&H Flatheads of La Crescenta, Ca.

The motor has been used for about two thousands miles with the results of:
  • Eight sleeves that were installed and bored and honed were done incorrect which has resulted in heavy blow by and excessive oil use. The sleeves have moved down in the block two thousands of an inch. The metal in sleeve no 2 cylinder has failed with small patched of voids in the cylinder walls. Water is leaking into cylinders 1 and 2.
  • The sealer paint that was used was done wrong which resulted in the paint flaking and got into the oil passages.

H&H will not stand behind there work and refuses to compensate me for my loses.

In your quote you state h&H refuses compensation either you spoke to him or you didn't. Which is it?
Ronnie is offline   Reply With Quote