[PhoenixFear]

There was quite a bit of work into these. Even though you would think it would be easy to make, I had to find the right sending units with the right measurements and then make the float arms based off an original. Here are some pics of the sending unit as well as the float arms themselves. So far everything seems to work fine, the only last piece of the puzzle is the new sending unit does not have the locating tab underneath like original to go into the slot on the tank. I am not sure if this will make a difference because there really is only one way to put the sending unit in. I had the float arms zinc plated. Original sending unit on top, new one on the bottom.