Re: Steering stabilizer
Did some checking and found a few questionable things. The right spindle arm where it goes into the spindle was loose. The radius rod appears to be secure, but the toe in is 1 and 1/16 inches, a bit much I think as the book says 1/16 to 1/32". The left wheel bearing was a bit loose, and the wheels appear to be out of balance. No one in Custer will try to balance them, so I spit into the wind and balanced them on the spindle not too good I'm afraid will get it to town soon and get a pro to do it. Haven't set the toe yet will tomorrow and then see where we are.Fred
|