The Ford Barn - View Single Post

jimTN · 12-17-2010, 08:48 AM

36tbird the engine is a 48 back 100 horse power block bored .60 over witn 49 to 53 Mercury 4" stroke crank. The dividers are held in by 7/16" allen screws (socket head cap screws) tignened into a counter sunk hole bored into the dividers. Those screws are in the bottom of the stud holes with the studs bottoming against them.

12-17-2010, 08:48 AM	#14
jimTN Senior Member Join Date: May 2010 Location: Powell, TN Posts: 2,508	Re: exhaust port dividers 36tbird the engine is a 48 back 100 horse power block bored .60 over witn 49 to 53 Mercury 4" stroke crank. The dividers are held in by 7/16" allen screws (socket head cap screws) tignened into a counter sunk hole bored into the dividers. Those screws are in the bottom of the stud holes with the studs bottoming against them.