View Single Post
Old 09-22-2011, 12:29 PM   #5
Ken/Alabama
Senior Member
 
Ken/Alabama's Avatar
 
Join Date: May 2010
Location: Alabama
Posts: 3,237
Default Re: Any tips for transmission,torque tube, and rear end install

Dont adjust on those fingers on the pressure plate. You will need a line up shaft when you install the clutch in case you arent familiar with that ,it goes throught the clutch and alignes and centers the clutch disc with the pilot bearing in the flywheel. Check that pilot bearing also ,make sure it turns smooth if its of the roller bearing type. On the speedometer cable, Pull the inner cable out of the housing and grease it before you install it . Be very carefull with those spring shackle bushings, that leaf spring can kill you.
Ken/Alabama is offline   Reply With Quote