View Single Post
Old 12-17-2010, 10:34 PM   #18
Karl Wolf
Senior Member
 
Karl Wolf's Avatar
 
Join Date: May 2010
Location: Mill Valley,Ca.
Posts: 1,509
Default Re: exhaust port dividers

Using a cut up 59ab block, I made a pattern for 1/8" stainless plate... Took a 7/16" nut, put it under the stud hole that runs into exhaust (exhaust valves out to access), marked finger tight position... Tig weld plate to nut, and use a long stud to hold them in place... Karl
Karl Wolf is offline   Reply With Quote