View Single Post
Old 01-26-2012, 05:34 PM   #25
Mac VP
Senior Member
 
Mac VP's Avatar
 
Join Date: May 2010
Location: Cincinnati, OH
Posts: 1,356
Default Re: T86 clutch and pressure plate

Hivolt....I just noticed your thread on the trans. I recently did that same trans for another customer, so I am familiar with it and the overdrive. FYI...the T86 trans was a Borg Warner unit and unfortunately NONE of the gears will interchange with the regular Ford standard trannies of that era.....except of course any other T86 from another Ford. We normally have most of the gears here and can get other pieces if needed from our other sources.

Judging from your pics.....and it was hard to see much, but I saw jagged teeth on the first gear portion of the cluster gear. You said that the 1st/reverse slider gear was also worn but I didnt see much in the pic. In either case, the wear on these two gears would certainly tend to cause problems with popping out of 1st gear.

We have all the gaskets and seals in fresh stock in case you need any of that. We also do rebuilding if you can't find anyone close to you for the work.

Was the overdrive part working ok?
__________________
VANPELT SALES LLC
Cincinnati, Ohio
Office: 513-724-9486
www.vanpeltsales.com
www.classictransmission.com
Mac VP is offline   Reply With Quote