View Single Post
Old 06-28-2010, 07:17 PM   #17
rotorwrench
Senior Member
 
rotorwrench's Avatar
 
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,346
Default Re: Bucking frame rivets

Maby it was one for vertical holes and one for horizontal holes. I'm sure what ever it was that is was the only way it would work most efficiently at the time. If they pierced the holes before they formed the rail it would be really difficult to get a good alignment. Left and right are different enough to warrant same processes for both sides but different jigging. I sure wish there were pictures of the process.

Last edited by rotorwrench; 06-28-2010 at 07:29 PM.
rotorwrench is offline   Reply With Quote