The Ford Barn - View Single Post

A-Jay · 07-10-2010, 10:15 PM

I just installed a Brassworks HD 10 fin per inch, in my 30 coupe. Its running nice a cool in 90's + temps, a nice well made unit that should last for many years. Had a problem with the moto meter, it would not fit in the new Rad. neck. I contacted Brassworks they were no help at all, acted like they had never heard such a thing. You have to take a Dremel tool to the outer edge where the hex bolts clamp down the lower part of the moto meter to the inner part of the neck. If you do replace also replace the two bottom bolts,cotter keys and the rubber pads and the springs, 7 to 10 bucks what the heck, your going to spend over $600.

07-10-2010, 10:15 PM	#7
A-Jay Senior Member Join Date: May 2010 Location: Fairfax, Va. Posts: 127	Re: Radiator for a driver I just installed a Brassworks HD 10 fin per inch, in my 30 coupe. Its running nice a cool in 90's + temps, a nice well made unit that should last for many years. Had a problem with the moto meter, it would not fit in the new Rad. neck. I contacted Brassworks they were no help at all, acted like they had never heard such a thing. You have to take a Dremel tool to the outer edge where the hex bolts clamp down the lower part of the moto meter to the inner part of the neck. If you do replace also replace the two bottom bolts,cotter keys and the rubber pads and the springs, 7 to 10 bucks what the heck, your going to spend over $600.