View Single Post
Old 06-27-2010, 03:25 PM   #6
Brentwood Bob
Senior Member
 
Join Date: May 2010
Location: brentwood, ca
Posts: 4,215
Default Re: Bucking frame rivets

Sponsored Links (Register now to hide all advertisements)
Took 3 of us to rivet a replacement front cross member. The frame was suspended from the rafter and had the running board brackets in place. We used the acetylene torch and a bucking bar that rested on the concrete floor. Did this manually, so you can do it with out a rivet hammer. Marco's technique is optimum, but there are other ways to get the job done.
Brentwood Bob is offline   Reply With Quote