The Ford Barn - View Single Post - ~~DirtyDan's 1936 Ford Coupe Project

BobM · 03-29-2011, 02:57 PM

Dan, job well done; that's how a real "hot rod" should look IMO. I too have a '36 & would like to do some of the things you have: how did you remove center section at the x-member with the body on? Is that the original '36 steering in the car, did you have to change water pumps, what oil pan did you use? Is the front axle also narrowed? Will you have an emergency brake? Am also concerned about front tire clearance (inner fender & wishbone?)

03-29-2011, 02:57 PM	#13
BobM Senior Member Join Date: May 2010 Location: Las Vegas, NV Posts: 213	Re: ~~DirtyDan's 1936 Ford Coupe Project - Build Pictures~~ Dan, job well done; that's how a real "hot rod" should look IMO. I too have a '36 & would like to do some of the things you have: how did you remove center section at the x-member with the body on? Is that the original '36 steering in the car, did you have to change water pumps, what oil pan did you use? Is the front axle also narrowed? Will you have an emergency brake? Am also concerned about front tire clearance (inner fender & wishbone?)