The Ford Barn - View Single Post

PhoenixFear · 10-05-2011, 07:50 PM

I believe the pistons measure 3.15".
I'm not expecting the motor to be worth much, just weighing all my options to figure out the best way to go. I'm looking at perhaps a $400 valve job, not sure if that includes the parts or not. Then need a radiator, unless I can have mine recored. $90 for each water pump, maybe less if they can be rebuilt. At this point I may as well have the engine hot tanked and magnafluxed. If the motor ran I wouldn't consider selling it, however I am trying to see what options I have, cost considered.

10-05-2011, 07:50 PM	#8
PhoenixFear Senior Member Join Date: Jun 2010 Location: Utica, MI Posts: 361	Re: Flathead engine worth I believe the pistons measure 3.15". I'm not expecting the motor to be worth much, just weighing all my options to figure out the best way to go. I'm looking at perhaps a $400 valve job, not sure if that includes the parts or not. Then need a radiator, unless I can have mine recored. $90 for each water pump, maybe less if they can be rebuilt. At this point I may as well have the engine hot tanked and magnafluxed. If the motor ran I wouldn't consider selling it, however I am trying to see what options I have, cost considered.