[GB SISSON]

Thanks, I'm still a bit up in the air about lifters. I have 2 complete sets of old Johnsons. One from a cracked block tear down and one set from a swap meet. I ended up with 2 of the same sioux valve face surfacers (both were given to me) I have been swapping parts around and will end up with a really nice one. Been experimenting with the stem grinding and it is very satisfying. I can see this becoming like a 'which cam?' thread, so in the end I alone will have to decide. I have been out in the shop this morning messing with cleaning up cams on my lathe. Ford's book says to discard a cam with journals less than 1.7955. My new inserted bearings are 1.799. Right now I am of course walking the line between nicely polished journals and too small. Lastly, what does anyone know about an 8RT cam? NOS Ford in cosmoline are available for less than 200 bucks. (military?) Very little written about them on the web, but most say they think it's same as 8BA.