The Ford Barn - View Single Post

motordr · 12-13-2023, 02:06 PM

If you can find rod bearings that are undersize for the crank pin and oversize for the connecting rod bore, your machinist can then hone the con rod big ends to fit the bearing thereby restoring to original clearances.

12-13-2023, 02:06 PM	#8
motordr Senior Member Join Date: Nov 2010 Location: Beamsville,Ontario,Canada Posts: 485	Re: Tap rod bearings into shape?? If you can find rod bearings that are undersize for the crank pin and oversize for the connecting rod bore, your machinist can then hone the con rod big ends to fit the bearing thereby restoring to original clearances.